Skip to Content
2016 Giben KG -365 Edgebander 


 

 

   

                      

 Premill – Premelt - Gluing - End trim - Top and bottom trim - Scrape - Buffing 

The KG 365 is ideal for the application of veneer and coiled PVC from 0.4 up to 3 mm of thickness and strips up to 5 mm of thickness. 

Standard Configuration: 

  • Speed 12-20 m/min. (may vary depending on additional groups) 
  • Chain drag with manual lubrication of the sliding guides 
  • Support bar at 700 mm. extractable 
  • Maximum panel height 60 mm. 
  • Maximum edge thickness 3 mm. 
  • Minimum length 120 mm. 
  • Minimum width 80 mm. 
  • Voltage  

Guide for Effective Length 400mm 

  • In tempered iron steel 
  • Safety device for remote input panels by mechanical locking 
  • PLC FOR THE ADJUSTMENT OF GROUPS 
  • Control of each unit on/off speed 
  • For banding ABS and PVC edges or similar materials 

Plate for Edge Roll 

  • Autoloader with curled roller. 
  • Introduction of PVC and ABS edges. 
  • Shearing machine for cutting roll edges max 3 mm. thick. 

Glue Group 

  • Automatic loading of edgebanding material in rolls and applying glue onto the panel. Glue pot for melting with fast heating; application roller with device to adjust the glue quantity that is applied on the panel; dual digital electronic control of the temperature in the tank and on the roller. 
  • 2 resistors: one on roller 250 W and the second in a glue tank 1500 W. 
  • Temperature sensor roller. 

Pre-Melting Glue System 

  • Quick change glue pot (top pot capacity 5KG lower pot capacity 2KG. 

Profile Scraper: 

  • Removal of material to clean the profile shape from possible imperfections from the trimmer tooling. 
  • Tools included. 
  • Structure in cast iron solid base and vertical development. 
  • Manual tool adjustment. 

Cutting Head: 

  • Solid cast iron structure with vertical development and moving with motors on precision linear guides. 
  • 2 motors (0.35 kW) 12 000 min-1  200 Hz. 
  • Two position pneumatic adjustment (straight and angle). 
  • Blades (included): 
  • Diameter 104 mm. 
  • Internal diameter 32 mm. 
  • Thickness 2 mm. 

Top & Bottom Fine Trimming Group: 

  • 2 motors (0.7 kW)  18 000 min-1  300Hz 
  • each motor is equipped with manual groups adjustment. 
  • Tools with heads and cutters diameter 69 mm. 
  • Z6 with profiles on request. 
  • 3 mm tooling standard 

Profile Scraper: 

  • Removal of material to clean profile shape from possible imperfections from trimmer tooling. 
  • Tools included. 
  • Structure in cast iron solid base and vertical development. 
  • Manual tool adjustment. 

Buffing Unit: 

  • Two buffing wheels of resistant cloth for cleaning panels and boards. 
  • 2 motors (0.30 kW) 200 Hz 1 200 min.-1 

 

Priced at $20,000.00